2009 JSW. Oct 23, 2014. #1. 2009 JSW with 150K miles. I had the CEL light appear and I downloaded the codes and it showed the following code. P2457 - EGR cooling Performance. The car seams to be running fine. If you clear the code it comes back after about 60 - 100 miles. Any one have any ideas, I have search the web and have not found the same
I decided to remove and clean the EGR valve housing on my wife's corsa 1.7 cdti sri as we were having issues with erratic idle & stalling when starting from
Answer. The management and control unit for the Opel Corsa D's airbag safety system is located inside the passenger compartment, just below the dashboard center console, or in front of the gear lever. Posted on: 13 October 2021 by ScegliAuto.

How to clean an EGR valve without dismantling with a Bardahl EGR valve cleaner kit The video uses the pack 9010 and follows the instructions given saying to

1 post · Joined 2011. #2 · Jun 10, 2011. It's literally on the right hand side of the engine if you stand at the front of the engine bay. It's a silver cylinder sticking up wards. Got torques bolts and a wiring connector on top and a coolant hose entering it which comes from the bulk head ( from the cabin ). I'm after removing and cleanning
Fuel filter and housing out the way. Boost pipes out the way. Might have to that the inlet manifold off. Drain the coolant out and disconnect the pipes. Then remove the solinoid on top to see what your doing better. Then remove the valve and clean up/replace/blank. Full 308mm Brake setups from £270 - CLICKY.
Where is the EGR valve located on a 1998 Opel Corsa? at the very front of the transmission. How do you replace an EGR valve on a 2000 Dodge Stratus 2.4 engine? Who is online. In total there are 6 users online :: 5 registered, 0 hidden and 1 guest (based on users active over the past 15 minutes) Most users ever online was 330 on Tue Jan 03, 2023 2:50 am. There are different EGR system designs in use today. Although the specifics of each system may vary, all use some type of EGR valve. When conditions are correct, the PCM commands the EGR valve to open, allowing exhaust gases to be recirculated into the engine’s intake manifold. Introducing these inert gases into the engine lowers combustion eYjDz.
  • 82uf0sfdqx.pages.dev/484
  • 82uf0sfdqx.pages.dev/10
  • 82uf0sfdqx.pages.dev/220
  • 82uf0sfdqx.pages.dev/419
  • 82uf0sfdqx.pages.dev/391
  • 82uf0sfdqx.pages.dev/310
  • 82uf0sfdqx.pages.dev/228
  • 82uf0sfdqx.pages.dev/488

    • corsa b egr valve location